Extractor

The extractor/range hood was part of the plan, but we spent ages trying to find one that wasn't $1000 and eventually this is what we came up with

Assembled, but there's a problem

The mounting hardware was about 16 inches too long, this meant that the gap between the cooktop and extractor was about 9 inches. Not good, but the grinder helped trim the whole down.

Here's how we kept it level and in place whilst installed.

Here's the front side of the chimney after screwing it together at back. As i'd trimmed down the mounting, the thing did not sit square on the ceiling. Easily fixed with screws

Suprisingly the chimney pipe thing lined up with the vent in the roof. Shame it was 2.5 inches different in diameter

Here's the final result